Skip Navigation Website Accessibility



 


Quilters Select: Print & Piece - Lite

Directions for Use and Care

Directions for general sse as a stabilizer for embellishment:

  • Heat iron to silk setting (low).
  • Position the fusible side of Print & Piece Fuse Lite over the wrong side of the fabric.
  • Cover the stabilizer with a cotton pressing cloth or piece of muslin. It is also OK to press from the fabric side instead of the stabilizer side.*
  • Press with the iron with an up-and-down motion, not side-to-side. If a bond is not achieved, slightly increase your iron temperature and try again.**
  • Once stitching is complete, slightly dampen the stitching line and pull away the stabilizer.

*Remember that all irons heat differently. We recommend testing on scrap fabric before beginning your project. 

**The fusible coating on the stabilizer was designed to be temporary. If the iron temperature used is too hot, the bond may become permanent.

Directions for needle turn appliqué:

  • Print or trace the image on to the non-fusible side of the stabilizer.
  • Trim away the excess stabilizer by cutting directly on the lines.
  • Fuse the stabilizer/image onto the wrong side of the fabric being used for the appliqué.
  • Trim the fabric to within a generous ¼? of the stabilizer/ image.
  • Use a fabric-safe glue stick and lightly coat the edge of the stabilizer/image.
  • Turn the fabric so that it sticks to the glue.
  • The appliqué is now ready to be stitched into place on your quilt block, garment or home dec project!
  • There is no need to remove the stabilizer from behind the appliqué: when washed, half of the fibers will dissipate; the other fibers will create a slight loft under the appliqué.

Washer and Dryer Safe

Cool water and low drying temperature recommended.

Press using a medium setting on your iron.

Size Available

QSPPFL-811
25 pieces 8½" x 11" printable sheets (21.59 cm x 27.9 cm)

 

  • 407 Broad Street, Story City, IA 50248
  • Ph: (515) 733-0182
  • Hours: Mon-Sat 10-6 CST, closed Sundays
  • info@itssewtempting.com